Set up your Agworld farms and fields as Figured properties and fields. This step requires some mapping in order to create new properties and fields using the Agworld data, or to override properties and fields that you already have in Figured.

1. Create a mapping between the Agworld Farm and Figured Property by using the drop-downs.

  • You may choose to map the Agworld farm to an existing Figured property. This will allow you to map the fields within that Agworld farm to fields existing in that Figured property, and create any additional fields as required. Mapping Agworld farms/fields to anything already existing in Figured will override the data you had in Figured as it will now be maintained by Agworld data.

  • You may choose to ‘Create New Property’ for that Agworld Farm. This will take the data you have in Agworld and set up that farm as a Figured property with all associated fields.

Figured's Agworld integration will use the farms and fields set up for your most recently created current season.

Note: You may experience some slowness on this page, especially if you have a lot of fields. It is best to just select the Agworld Farm, wait for the fields to load and then select the Figured Property to avoid any issues. Please allow a couple of minutes if you select the Agworld Farm and then the Fields don't seem to load, they usually pull through after a while.

2. Hit Confirm once you have finished and you will see a confirmation message with a link to your Properties section in Figured.

You can view the Properties and Fields as you would normally. Any Properties and Fields that are connected to Agworld will show with the Agworld icon and are read-only.

You can choose to leave your Integration Setup there, or finish it to pull in products and costs from Agworld.

Read about the next step here.

Did this answer your question?