Set up your Agworld farms and fields as Figured properties and fields by going to Settings>Operation>Agworld Integration. This step requires mapping to create new properties and fields using the Agworld data or to override properties and fields you already have in Figured.

First, create a mapping between the Agworld Farm and Figured Property by using the drop-downs.

You may choose to map the Agworld farm to an existing Figured property. This will allow you to map the fields within that Agworld farm to fields existing in that Figured property and create any additional fields as required. Mapping Agworld farms/fields to anything already existing in Figured will override the data you had in Figured, as Agworld data will now maintain it.

You may choose to ‘Create New Property’ for that Agworld Farm. This will take your data in Agworld and set up that farm as a Figured property with all associated fields.

Figured's Agworld integration will use the farms and fields set up for your most recently created current season.

Note: You may experience some slowness on this page, especially if you have a lot of fields. It is best to select the Agworld Farm, wait for the fields to load and then select the Figured Property to avoid any issues. Please allow a couple of minutes for the fields to load.

Hit Confirm once you have finished, and you will see a confirmation message with a link to your Properties section in Figured.

You can view the Properties and Fields as you would normally. Any Properties and Fields connected to Agworld will show with the Agworld icon and are read-only.

You can leave your Integration Setup there or set it up to pull products and costs through from Agworld.

Read about the next step here.